Changes to Step #5
Edit by NATHAN M. DENKIN —
Edit approved by NATHAN M. DENKIN
- Before
- After
- Unchanged
Step Lines
| [title] Disassembly | |
| [* 1] 1. Unload the filament and allow the hot end to cool. Turn off the printer and remove the power plug. | |
| [* 1] 2. Protect the printing surface and use a tray to catch small components that might fall during the disassembly. | |
| - | [* 1] 3. Remove the m3x40 screw securing the Rambo/Einsy cover and disconnect all connectors from the extruder cable. |
| - | [* 1] 4. Cut the zip ties and remove the screws clampling the extruder cable and remove the 3mm nylon filament. Completely unwind the cables. |
| + | [* 1] 3. Remove the m3x40 screw securing the Rambo/Einsy cover and disconnect all the plugs from the extruder cable. |
| + | [* 1] 4. Cut the zip ties and remove the screws clampling the extruder cable to the Rambo/EINSY box and remove the 3mm nylon filament. Completely unwind the cables. |
| + | [* 1] Cut the zip ties securing the extruder cable on the cable guide and remove the cable wrapping. Untangle the wires. |
| [* 9] Be careful to not cut the cables while cutting the zip ties. |