Changes to Step #5

Edit by Dave Ogles —

Edit approved by Dave Ogles

Before
After
Unchanged

Step Lines

[title] Disassembly
[* 1] 1. Unload the filament and allow the hot end to cool. Turn off the printer and remove the power plug.
[* 1] 2. Protect the printing surface and use a tray to catch small components that might fall during the disassembly.
-[* 1] 3. Remove the m3x40 screw securing the Rambo/Einsy cover and disconnect all the plugs, from the board that make up the extruder cable bundle.
+[* 1] 3. Remove the M3x40 screw securing the Rambo/Einsy cover and disconnect all the plugs, from the board that make up the extruder cable bundle.
[* 1] 4. Cut the zip ties and remove the screws clamping the extruder cable to the Rambo/EINSY box and remove the 3mm nylon filament. Completely unwind the spiral/fabric wrap from the cables.
[* 1] Cut the zip ties securing the extruder cables on the cable guide and remove the cable wrapping. Untangle the wires.
[* 9] Be careful to not cut the cables while cutting the zip ties.