Changes to Step #7
Edit by NATHAN M. DENKIN —
Edit approved by NATHAN M. DENKIN
- Before
- After
- Unchanged
Step Lines
| [title] Disassembly | |
| [* 1] 1. Cut the zip ties holding the extruder assembly to the linear bearings. | |
| [* 1] 2. Remove the timing belt. Replace if worn or damaged. | |
| [* 1] 3. Carefully pull the wires through the x-end assembly | |
| [* 1] 4. Tear down the entire extruder by reversing the assembly instructions provided by Prusa. | |
| - | [* 1] 5. All the printed parts will be replaced. Most of the electrical parts and fasteners |
| - | [* 1] 6. Check all wires and connectors for possible damage |
| + | [* 1] 5. All the printed parts will be replaced. Most of the electrical parts and fasteners can be reused. |
| + | [* 1] 6. Check all wires and connectors for possible damage especially where wires made tight bend or may have been clamped too tightly. |
| [* 1] 7. Check the PFTE tubes for possible damage. |