Changes to Step #6

Edit by Dave Ogles —

Edit approved by Dave Ogles

Before
After
Unchanged

Step Lines

[title] Disassembly
[* 1] 1. Remove the screws holding the z-tops in place.
[* 1] 2. Pull the z-tops off the smooth rods. Try to avoid pulling the rods from the z-motor mounts. If a rod does come loose, avoid rotating it within the linear bearings.
-[* 1] 3. Remove the screws securing the trapezoidal nuts and spin those nuts to the top of the lead screws and remove them. They will be reused.
-[* 1] 4. Lift the x-end off the z-axis rods by lifting both the motor and idler mounts evenly.
+[* 1] 3. Remove the screws, securing the trapezoidal nuts to each x-end and spin those nuts to the top of the lead screws and remove them. They will be reused.
+[* 1] 4. Lift the x-ends off the z-axis rods by lifting both the motor and idler mounts evenly.
[* 1] 5. ***MK2.5(S) only:*** Remove the two M2x12 screws securing the x-end limit switch.
[* 1] 6. Remove the three screws holding the x-end motor.
[* 1] 7. Pull the rods out of the x-end-motor and idler mounts taking care not to bend or twist the rods.