Changes to Step #4

Edit by Dave Ogles —

Edit approved by Dave Ogles

Before
After
Unchanged

Step Lines

[title] Check your new printed parts
[* 1] Take the time to check your newly printed parts:
[* 1] Clean up strings with tweezers and hot air gun (be careful).
- [* 1] Carefully check inside holes of X ends smooth rods.
- [* 1] Remove possible elephant foot with a deburring tool.
- [* 1] Check all bridges. If a bridge is falling in its center: heat tweezers with a lighter and press on the bad looking zone to make it more flat.
- [* 1] Make sure the filament path of the extruder body is clean, round, and with no obstructions.
+ [* 1] Carefully check inside the holes of the X ends, where the smooth rods will be inserted.
+ [* 1] Remove any elephant foot with a deburring tool.
+ [* 1] Check all bridges. If a bridge is falling in its center: heat tweezers with a lighter(or use a soldering iron) and press on the area with the poor bridging, to make it more flat.
+ [* 1] Make sure the filament path through the extruder body is clean, round, and clear from obstructions.