Changes to Step #3

Edit by NATHAN M. DENKIN —

Edit approved by NATHAN M. DENKIN

Before
After
Unchanged

Step Lines

[title] Checking PTFE tube length
-[* 9] The Bear extruder is using a different PTFE tube length than MK2.5S and MK3S. The Bear extruder use the same PTFE tube length than MK2S, MK2.5 (non-S) and MK3 (non-S).
+[* 9] The Bear extruder uses a different PTFE tube length than MK2.5S and MK3S. The Bear extruder uses the same PTFE tube length as MK2S, MK2.5 (non-S) and MK3 (non-S).
[* 1] If you are coming from MK2.5S or MK3S, the assembly will guide you through the steps of preparing the PTFE tube.
[* 1] In case you need to prepare a new PTFE tube, make sure you have the following parts:
[* 8] Ptfe cutter jig (included in the printed parts).
- [* 7] Box cutter with a lame thickness of 0.4mm.
+ [* 7] Box cutter with a blade thickness of approximately 0.4mm.
[* 5] 60° countersink.
[* 4] Unused PTFE tube of at least 100mm.
-[* 10] Bear extruder PTFE tube must be 50mm.
+[* 10] Bear extruder PTFE tube must be 50mm in length and the ends must be cut square.