Changes to Step #2
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [title] How to insert nuts |
|---|---|
| + | [* icon_note] ***Inserting Hex Nuts:*** To assure that hex nuts are properly seated, do the following: |
| + | [* red] Insert a screw through a washer. |
| + | [* green] Insert the screw through the hole on the flat side (not the hex cavity side). |
| + | [* blue] Add the hex nut on the screw and tighten the screw. |
| + | [* icon_caution] Ensure the hex nut is aligned with the hex cavity while tightening. |
| + | [* black] When the nut is full seated, you may remove the screw being careful not to dislodge the nut. |
| + | [* icon_note] ***Inserting Nyloc Nuts:*** You can use the same method as hex nuts. |
| + | [* icon_note] ***Inserting Square Nuts:*** They tend to fall out if the piece holding them is inverted. After they are inserted, check that they are properly seated by inserting a screw to engage that nut. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added