Changes to Step #2

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] How to insert nuts
[* icon_note] ***Inserting Hex Nuts:*** To assure that hex nuts are properly seated, do the following:
[* red] Insert a screw through a washer.
[* green] Insert the screw through the hole on the flat side (not the hex cavity side).
[* blue] Add the hex nut on the screw and tighten the screw.
[* icon_caution] Ensure the hex nut is aligned with the hex cavity while tightening.
- [* black] When the nut is full seated, you may remove the screw being careful not to dislodge the nut.
+ [* black] When the nut is full seated, you need to remove the screw being careful not to dislodge the nut.
[* icon_note] ***Inserting Nyloc Nuts:*** You can use the same method as hex nuts.
[* icon_note] ***Inserting Square Nuts:*** They tend to fall out if the piece holding them is inverted. After they are inserted, check that they are properly seated by inserting a screw to engage that nut.