Changes to Step #4
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [title] Disassembly |
|---|---|
| + | [* black] Cut the zip ties holding the extruder assembly to the linear bearings. |
| + | [* red] Remove the timing belt. Replace if worn or damaged. |
| + | [* orange] Carefully pull the wires through the x-end assembly |
| + | [* yellow] Tear down the entire extruder by reversing the assembly instructions provided by Prusa. |
| + | [* green] All the printed parts will be replaced. Most of the electrical parts and fasteners will be reused. |
| + | [* blue] Check all wires and connectors for possible damage |
| + | [* violet] Check the PFTE tubes for possible damage. |