Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Disassembly
-[* black] Cut the zip ties holding the extruder assembly to the linear bearings.
-[* red] Remove the timing belt. Replace if worn or damaged.
-[* orange] Carefully pull the wires through the x-end assembly
-[* yellow] Tear down the entire extruder by reversing the assembly instructions provided by Prusa.
-[* green] All the printed parts will be replaced. Most of the electrical parts and fasteners will be reused.
-[* blue] Check all wires and connectors for possible damage
-[* violet] Check the PFTE tubes for possible damage.
+[* black] 1. Cut the zip ties holding the extruder assembly to the linear bearings.
+[* black] 2. Remove the timing belt. Replace if worn or damaged.
+[* black] 3. Carefully pull the wires through the x-end assembly
+[* black] 4. Tear down the entire extruder by reversing the assembly instructions provided by Prusa.
+[* black] 5. All the printed parts will be replaced. Most of the electrical parts and fasteners will be reused.
+[* black] 6. Check all wires and connectors for possible damage
+[* black] 7. Check the PFTE tubes for possible damage.