Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by Grégoire Saunier

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Make PTFE External Chamfer
[* black] RepeatRemove the previous step but withblade and cutter jig from slit number 1.
[* black] Insert
the blade in the slit number 2. Make
[* black] Verify that the blade is at the bottom of the slit and parallel to bottom.
[* black] To protect your fingers make
sure the PTFEblade is fully insertedinserted (refer to previous steps in case of doubt).
[* black] While maintaining the blade with your thumb, insert all the way in the cutter jig until the PTFE tube is pressed against the end stop
.
[* blue] This time you need to rotate the tube counter-clockwise'''counter-clockwise''' (looking from the back of the cutter jig).
[* black] RepeatRemove the previous step but withblade and cutter jig from slit number 1.
[* black] Insert
the blade in the slit number 2. Make
[* black] Verify that the blade is at the bottom of the slit and parallel to bottom.
[* black] To protect your fingers make
sure the PTFEblade is fully insertedinserted (refer to previous steps in case of doubt).
[* black] While maintaining the blade with your thumb, insert all the way in the cutter jig until the PTFE tube is pressed against the end stop
.
[* blue] This time you need to rotate the tube counter-clockwise'''counter-clockwise''' (looking from the back of the cutter jig).