Skip to main content

Changes to Step #12

Edit by Grégoire Saunier

Edit approved by Grégoire Saunier


Step Lines

[title] Preheat Error for Hotend (1/2)
-[* black] Turn the printer off and then on.
+[* black] Turn the printer off.
[* black] Locate the hotend heater connector on your controller board:
[* orange] Rambo Mini hotend heater connector (MK2, MK2S, MK2.5 and MK2.5S).
[* green] Rambo Einsy hotend heater connector (MK3 and MK3S).
+[* black] Unplug the ***hotend heater*** from the Rambo board.
+[* black] Turn the printer on.
[* yellow] Preheat the heated bed and extruder for PLA temperature through the ''Preheat'' menu of your printer.