Changes to Step #1

Edit by Dave Ogles —

Edit approved by Dave Ogles

Before
After
Unchanged

Step Lines

[title] Install Y rod holders
-[* 3] Slide 6x t-nuts in top of the front extrusion.
-[* 7] Slide 5x t-nuts in top of the back extrusion.
-[* 5] Assemble 4x ''y_rod_holders'' with 8x M5x12 screws. Tighten them to avoid sliding, we will set the correct position later.
-[* 2] Verify you have used the correct t-nuts. You should have 2x free t-nuts in the middle of front and 1x free in the middle of the back.
+[* 3] Slide 6x t-nuts in the top of the front extrusion.
+[* 7] Slide 5x t-nuts in the top of the back extrusion.
+[* 5] Attach 4x ''y_rod_holders'' to the frame, using 8x M5x12 screws, as shown. Tighten them just enough to prevent sliding, we will set the correct position later.
+[* 2] Check that you have have 2x free t-nuts in the top middle of the front extrusion and 1x free t-nut in the top middle of the back extrusion.