Changes to Step #2

Edit by Dave Ogles —

Edit approved by Dave Ogles

Before
After
Unchanged

Step Lines

[title] Prepare Y idler mount
[* 5] Take the "y_idler_mount"
-[* 7] Slide 1x locknut from the back/under of the part. Make sure the locknut has been pushed down fully.
-[* 2] Screw 1x M3x25 screw into the front top hole. This will avoid to loose the locknut during the next steps.
+[* 7] Place 1x locknut in the pocket at the back of the part, as shown. Ensure sure the locknut has been fully inserted (use an Allen key or screwdriver) and is correctly oriented.
+[* 2] Thread 1x M3x25 screw through the front top hole and into the locknut. This will prevent you losing the locknut during the next steps.