Changes to Step #3

Edit by Dave Ogles —

Edit approved by Dave Ogles

Before
After
Unchanged

Step Lines

[title] Install Y idler mount
-[* 5] Slide 1x t-nut in the lower of the front extrusion
-[* 7] Using 3x M5x10, assemble the ''y_idler_mount''. Make sure to tighten the screw ***incrementally***. The exact position will be set later.
-[* 9] Always tighten the ''y_idler_mount'' ***incrementally***. This ensure the motor is getting squared correctly.
+[* 5] Slide 1x t-nut in the lower of the front extrusion, as shown.
+[* 7] Using 3x M5x10 screws, assemble the ''y_idler_mount''. Tighten them just enough to prevent the part from sliding. We will set the correct position later.
+[* 9] Do not fully tighten the part to the frame. We will adjust its final position when we align the belt path with the bed and motor.