Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #31

Edit by Grégoire Saunier

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* icon_reminder] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S].
-[* violet] Attach the heated bed textile sleeve (or spiral wrap) to the heated right of the electronic cover.
+[* violet] Place the heated bed textile sleeve (or spiral wrap) to the heated right of the electronic cover. Secure it with the printed part and 2x M3x10 screws.
[* icon_note] This is image shows the design of the MK3 B7/R3 or MK3S electronic cover. The MK3 B3/R2 design is slightly different.
[* blue] Using a Philips screwdriver, connect the heated bed wires:
[* red] Positive red wire goes on the red circle
[* black] Negative black wire goes on the black circle
[* blue] Tighten the screws ***firmly***.
[* icon_caution] Double check you have connected the wires in the correct order and orientation.

Image 1

Old Version

New Version

Image 2

No previous image

Added