Changes to Step #4
Edit by Florian Daeubler —
Edit approved by Florian Daeubler
- Before
- After
- Unchanged
Step Lines
| [title] Duet 3 Mini 5+ Installation | |
| - | [* 1] Insert wisdom here. |
| + | [* 5] Secure the board in ''duet_cover_back'' with 4x M4x10 screws. Be careful not to over-tighten the screws as this might damage the board. |
| + | [* 9] Make sure to use the washers that Duet3D includes with the Mini 5+ between the screw head and the board. Like this you avoid damaging any solder points when tightening the screws. |