Changes to Step #4

Edit by Florian Daeubler —

Edit approved by Florian Daeubler

Before
After
Unchanged

Step Lines

[title] Duet 3 Mini 5+ Installation
-[* 5] Secure the board in ''duet_cover_back'' with 4x M4x10 screws. Be careful not to over-tighten the screws as this might damage the board.
-[* 2] Make sure to use the washers that Duet3D includes with the Mini 5+ between the screw head and the board. Like this you avoid damaging any solder points when tightening the screws.
+[* 5] Secure the board in ***''duet_cover_back''*** with 4x ***M4x10mm*** screws. Be careful not to over-tighten the screws as this might damage the board.
+[* 2] Make sure to use the ***washers*** that Duet3D includes with the Mini 5+ between the screw head and the board. Like this you avoid damaging any solder points when tightening the screws.