Changes to Step #5

Edit by Florian Daeubler —

Edit approved by Florian Daeubler

Before
After
Unchanged

Step Lines

[title] WiFi Antenna Installation
-[* 9] Be careful when handling the antenna, especially the connection with the board is very sensitive and you should avoid putting any strain on it.
+[* 9] ***Be careful when handling the antenna, especially the connection with the board is very sensitive and you should avoid putting any strain on it.***
[* 10] The connection between antenna and the board is designed at an angle to optimize the wire position of the antenna which avoids unnecessary strain on the wire and board connection.
-[* 5] Insert the hex nut end of the antenna wire into the its pocket on the case.
-[* 3] Secure the wire to the case by screwing the included hex nut to the outside of the case until it is secured firmly.
- [* 4] Make sure to use the locking washer between the case and the hex nut.
-[* 8] Lastly attach the antenna by screwing it on the remaining thread.
+[* 5] Insert the ***hex nut end*** of the ***antenna wire*** into the its pocket on the case.
+[* 3] ***Secure the wire to the case*** by screwing the included ***hex nut*** to the outside of the case until it is secured firmly.
+ [* 4] Make sure to use the ***locking washer*** between the case and the hex nut.
+[* 8] Lastly ***attach the antenna*** by screwing it on the remaining thread. We suggest to angle the antenna like in picture 3, so it will not be sticking out to the side of the frame later.