Changes to Step #10
Edit by Florian Daeubler —
Edit approved by Florian Daeubler
- Before
- After
- Unchanged
Step Lines
| [title] Case Mounting II | |
| - | [* 1] Insert wisdom here. |
| + | [* 2] Remove the Z end cap on the left Z extrusion (left when standing in front of the printer). |
| + | [* 5] Slide the T-nut into the outside slot on the backside of the left Z extrusion. |
| + | [* 3] Slide the case down together with the inserted T-nut. |
| + | [* 8] Until the bottom of the case touches the top surface of the extrusion on the back of the XY-frame. |
| + | [* 9] Do not tighten the screw yet. |