Changes to this Step

Edit by Florian Daeubler —

Edit approved by Florian Daeubler

Before
After
Unchanged

Step Lines

-[title] Case Mounting IV
+[title] Wire Management
[* 5] The extruder wire bundle will be entering the case on the top left opening.
[* 3] The heated bed wire bundle will be entering the case on the bottom left opening.
[* 4] Both the extruder wire bundle and the heated bed wire bundle will be secured with the ***''board_cable_clamp_extruder''*** and the ***''board_cable_clamp_bed''*** (picture 2).
[* 4] Secure both cable clips with 4x ***M3x10mm*** screws (picture 3).
[* 8] The X-axis motor wire will be entering the case on the top right opening.
- [* 8] The X-axis motor wire will be fixed with a ***zip tie*** (picture 2).
+ [* 8] The X-axis motor wire will be fixed with a ***zip tie*** (picture 3).