Changes to Step #7
Edit by Florian Daeubler —
Edit approved by Florian Daeubler
- Before
- After
- Unchanged
Step Lines
| + | [title] Connectivity WiFi vs Ethernet |
|---|---|
| + | [* 1] ***WiFi Only:*** If you have the WiFi version of the Duet 3 Mini 5+ you secured the antenna wire earlier in this guide. |
| + | [* 5] You can cover the cut-out for the ethernet connector with ***''rj45_cap''***. |
| + | [* 3] ***Screw the antenna to the thread ***pointing out of the case. We recommend to angle the antenna as shown in picture 2 to avoid damaging it while working on the printer later. |
| + | [* 1] ***Ethernet Only:*** If you have the Ethernet version of the Duet 3 Mini 5+ you did skip the steps to attach the antenna wire earlier. |
| + | [* 8] There will be no thread sticking out of the board as we will not be attaching an antenna to the board. ***Leave the ''rj45_cap'' off the case*** as the cut-out will allow you to attach an ethernet wire to the board. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added