1. Hardware Assembly Step History

Changes to this Step

Edit by Florian Daeubler — Jun 13, 2021

	[title] PanelDue Mounting II
	[* 2] You can now re-add the *end cap* you removed earlier.
	[* 5] When plugging the *wire* into the *PanelDue, you can route it through the channel* in the right support.
	[* 8] *Fix the wire* to the support with a *zip tie*. This will avid unnecessary strain on the wire/connector when moving the printer around later.
+	[* 9] *Be careful not to pull the zip tie too tight as this could damage the wire!*

	[title] PanelDue Mounting II
	[* 2] You can now re-add the *end cap* you removed earlier.
	[* 5] When plugging the *wire* into the *PanelDue, you can route it through the channel* in the right support.
	[* 8] *Fix the wire* to the support with a *zip tie*. This will avid unnecessary strain on the wire/connector when moving the printer around later.
+	[* 9] *Be careful not to pull the zip tie too tight as this could damage the wire!*