Changes to this Step

Edit by Florian Daeubler —

Edit approved by Florian Daeubler

Before
After
Unchanged

Step Lines

[title] PanelDue Mounting II
-[* 2] You can now re-add the ***end cap*** you removed earlier.
-[* 5] When plugging the ***wire*** into the ***PanelDue***, you can route it through the ***channel*** in the right support.
-[* 8] ***Fix the wire*** to the support with a ***zip tie***. This will avid unnecessary strain on the wire/connector when moving the printer around later.
+[* 2] You can now re-add the end cap you removed earlier.
+[* 5] When plugging the wire into the PanelDue, you can route it through the channel in the right support.
+[* 8] Fix the wire to the support with a ***zip-tie***. This will avid unnecessary strain on the wire/connector when moving the printer around later.
[* 9] ***Be careful not to pull the zip tie too tight as this could damage the wire!***