Changes to Step #12
Edit by Florian Daeubler —
Edit approved by Florian Daeubler
- Before
- After
- Unchanged
Step Lines
| - | [title] Antenna |
|---|---|
| + | [title] WiFi Only - Antenna Installation III |
| [* 5] Screw the antenna on the thread sticking out of the case. Make sure it is secured firmly but do not over-tighten, not much force is needed. | |
| [* 9] We recommend to angle the antenna as shown in ***picture 2*** as this will prevent it from sticking out of the frame too much. Otherwise you might damage it while working on or moving the printer later. | |
| [* 1] Congratulations, you have successfully mounted the board and its case! We will now mount the PanelDue in the following steps. |