Changes to Step #1

Edit by Matthew Harrison —

Edit approved by Matthew Harrison

Before
After
Unchanged

Step Lines

[title] Preparation
-[* 9] If you have setup a different estep value than stock in the past I recommend to reset it to its default.
-[* 10] We recommend a micrometer instead of caliper for the following steps. Caliper are not precise enough to measure such small values and a micrometer has a ratchet system made to apply same pressure for all measures.
-[* 11] If you need to buy a micrometer, choose a quality one. Digital micrometers are not necessarily more accurate and precise. In most cases, noname digital micrometers are worse than quality analog ones. Some recommended brands: Tesa, Mitutoyo, Etalon, Mahr.
-[* 9] Make sure to use the temperature you are using for printing the filament. Do not change the temperature during these steps. Temperature might change the flow and so extrusion multiplier.
+[* 9] If you have set up a different extruder steps/mm value than stock in the past I recommend resetting it to its default.
+[* 10] We recommend a micrometer instead of calipers for the following steps. Calipers are not precise enough to measure such small values and a micrometer has a ratchet system made to apply same pressure for all measures.
+[* 11] If you need to buy a micrometer, choose a quality one. Digital micrometers are not necessarily more accurate and precise. In most cases, no-name digital micrometers are worse than quality analog ones. Some recommended brands are Tesa, Mitutoyo, Etalon, Mahr.
+[* 9] Make sure to use the temperature you are using for printing the filament. Do not change the temperature during these steps. Temperature might change the flow and therefore the extrusion multiplier.