Changes to Step #4
Edit by Austin Vojta —
Edit approved by Austin Vojta
- Before
- After
- Unchanged
Step Lines
| [title] Extrusion multiplier and filament diameter settings | |
| [* 3] Start PrusaSlicer and load the calibration model. On the main page, select the following parameters: | |
| [* 3] Print settings: 0.20mm QUALITY | |
| [* 3] Filament: Generic PETG (or whatever filament type for which you are calibrating) | |
| [* 7] Enter your measured filament diameter into the corresponding input under filament settings. | |
| - | [* 8] Ensure "Extrusion multiplier" is reset to 1. |
| + | [* 8] Ensure "Extrusion multiplier" is reset to 1.00. |