Changes to Step #4
Edit by Matthew Harrison —
Edit approved by Matthew Harrison
- Before
- After
- Unchanged
Step Lines
| [title] Extrusion multiplier and filament diameter settings | |
| [* 3] Start Slic3r PE and load the calibration model. On the main page, select the following parameters: | |
| [* 3] Print settings: 0.20mm Normal | |
| [* 3] Filament: Prusa PLA | |
| [* 7] Report filament diameter to the filament settings. | |
| - | [* 8] Reset "Extrusion multiplier" to 0. |
| + | [* 8] Reset "Extrusion multiplier" to 0.95. |
| [* 5] ***MK3(S) only:*** disable by commenting the M221 command line in Printer Settings -> Custom G-code -> Start G-code |