1. Unload the filament and allow the hot end to cool. Turn off the printer and remove the power plug.
2. Protect the printing surface and use a tray to catch small components that might fall during the disassembly.
3. Remove the m3x40 screw securing the Rambo/Einsy cover and disconnect all connectors from the extruder cable.
4. Cut the zip ties and remove the screws clampling the extruder cable and remove the 3mm nylon filament. Completely unwind the cables.
Be careful to not cut the cables while cutting the zip ties.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.