Remove the blade from slit number 1.
Insert the blade in slit number 2.
Verify that the blade is at the bottom of the slit and parallel to the bottom.
To protect your fingers, make sure the blade is fully inserted (refer to previous steps in case of doubt).
While holding the blade with your thumb, insert the PTFE tube all the way in the cutter jig until it is pressed against the end stop.
This time you need to rotate the tube counter-clockwise (looking from the back of the cutter jig).
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.