The Bear Project is not a company, it is a project that helps to make your 3D printing experience better. You are responsible for your upgrades and any damage you may cause.
The Bear Project can only officially provide support for
The original Prusa hardware and software
The Bear frame supplied by our official distributors
The Bear extruder (with the calibration firmware used only for calibration and selftest)
You need to use our recommended filament and print settings because those are the conditions used to design and test our products.
We are providing optional parts for other extruders or hardware but unfortunately we don’t have time to test them and so we can’t support them officially. Those optional parts might require different firmware over which we have no control and don’t know how well they are tested. Please refer to their manual, assembly instructions and support.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.