Skip to main content
Editing Step 4 —

Step Type:

Drag to rearrange

Temporarily insert a 8mm smooth rod through both LM8UU linear bearings.

Engage two M3x10 socket head screws in the hex nuts, but do not tighten them at this time.

Alternatively tighten the two M3x10 clamp screws to secure the linear bearings. Slide the smooth rods back and forth while tightening.

Don't over-tighten the clamp screws; they need to be just tight enough to keep the bearings from moving.

Remove the 8mm smooth rod.

Your contributions are licensed under the open source Creative Commons license.