Help
Editing Step 5 —

Step Type:

Drag to rearrange

Repeat the 3 previous steps on x_end_motor

MK2s and MK2.5 only: Use two M2x12 screws to attach the x-endstop switch. Ensure the correct orientation of the switch.

MK2s and MK2.5 only: While tightening the screws, apply gentle pressure in the direction shown.

MK2s and MK2.5 only: Do not to over-tighten the M2x12 screws!

MK2s and MK2.5 only: Double check x-endstop switch orientation

Your contributions are licensed under the open source Creative Commons license.