Insert the idler in the x_end_idler_idler_mount.
Press the dowel pin through the x_end_idler_idler_mount and idler bearings.
Verify that the dowel is not protruding from either side.
Verify that the idler spins freely.
Insert two M3 nylock nuts in the top and bottom of x_end_idler_idler_mount. Note the orientation of the nylock nuts.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.