The 2GT 16T pulley grooves are not visible on the images
Position the 2GT 16T pulley so that approximately 3.5 to 4 mm of the shaft protrudes. Ensure the pulley is not touching the motor.
Align one of the set screws on the motor shaft flat and then tighten alternatively both set screws until they are both snug.
Using three M3x18 screws, attach the x-axis motor. Note the orientation of the wires.
Double check the pulley position and ensure it does not touch the motor
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.