Insert two M3 hex nuts in the dedicated pockets of x_end_idler.
Note the orientation of the trapezoidal nut.
Insert a trapezoidal nut on top of x_end_idler.
Using two M3x18 screws, tighten the trapezoidal nut. Don't over-tighten the screws. They will be loosened and re-tightened after the x-end has been mounted on the z-axis rods.
Verify trapezoidal orientation.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.