Help
Editing Step 14 —

Step Type:

Drag to rearrange

Check that z_tops and "z_end_caps" have been removed.

Carefully slide the X axis assembly onto the Z-axis. Rotate the lead screws to engage the X axis in the trapezoidal nuts.

Continue to rotate the lead screws with your fingers to move down the X axis assembly by few centimeters. If the X end is not parallel with the horizontal v-v-slot at the top of the Z axis, rotate one side to make the X axis assembly parallel to top of Z axis.

Continue to move the X axis assembly down to the middle of the Z axis. Keep the X axis as flat as possible

Your contributions are licensed under the open source Creative Commons license.