Étienne Vincent

it is maybe an error but I didn’t have a M5x16 screw in the package, I had to buy a stock of M5x15. It would be nice to use the same M5x12 screw as the other parts

I’m I the only one with M2 screws not screwing in? maybe the printing was too large

tips: i didn’t had an idler, so I cut the head of a M3 screw with a metal saw

depending on the material you used for the print, it is way easier with some lub (the one I use for the bearings anyway)

I had difficulties since the printer put some supports and it was difficult to removed them. It results in a difficulty to insert the nut (I had to force thus the nut was not in the correct position, flat on top). At the end the nut was moving freely inside and no possibility to remove it. I put glue and it’s fine now. Maybe redesign the part so you can remove the nut from the bottom if it stuck