Hello Grégoire, as I have a Prusa MKiii (3) which cuts down the system everytime when I want to heatup my hotend . In other words, I set the hotend for PLA, than push go, the system stops. iow: There is a safety features within the firmware which stop the hot end from heating if a fault is present . On this moment I didnot found the fault yet. However,thanks for your contribution, whichs helps me a lot, in the right direction, probably a small issue, but difficult to find. Greetz Ben from Holland
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
Hello Grégoire, as I have a Prusa MKiii (3) which cuts down the system everytime when I want to heatup my hotend . In other words, I set the hotend for PLA, than push go, the system stops. iow: There is a safety features within the firmware which stop the hot end from heating if a fault is present . On this moment I didnot found the fault yet. However,thanks for your contribution, whichs helps me a lot, in the right direction, probably a small issue, but difficult to find. Greetz Ben from Holland