Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Reputation Breakdown
No reputation gained yet.
349
Hi, I printed this part 4 times with tuned flow settings, horizontal expension of 0.1mm for accurate inner hole size etc. The hole where the 8mm rod fits is not bigger than 8mm. This results in part exploding between layers every single time. This time I used my dremel and carved the insides enough for rods to go through all the way. One side went fine the other exploded. I have wasted immense amount of time and material on this part because tolerances are non existent. I also had multiple parts breaking from the embedded nuts because the holes for the nuts are too small. Same goes for the X axis carriage. There is no way the belt goes between the grooves. I printed X carriage 5 times with decreasing flow and increasing the scale on XY axis because I am printing with ASA yet belt never fits. Can you provide parts with acceptable tolerances?