Editing joa14pnz2goznpcu

[flag|private] [title|Release Note 0.6.0-alpha] [summary_image|826] === Improvements === ==== X Ends ==== * Moved the X pulley closer to the X motor to prevent the motor shaft from being bent. * Improved the X end idler mount to accommodate a misaligned belt and larger idler pulley. * Increased the stiffness of X end idler mount, however it now requires a 15mm to 15.8mm long dowel pin replacing 14mm pins. * Improved nut pocket holes. * Improved selective infill on both X ends. * Improved fitting of idler mount in the X end idler to ensure best possible alignment. * This new version is compatible with the previous one (0.50-alpha). ==== Extruder ==== * Greatly improved hotend cooling. The cooling fan has been moved and exhaust has been opened. * Reworked the filament sensor pocket and cover: ** Improved filament path to ease insertion. ** Improved protection of the laser sensor. ** Moved the cover screws to allow a more compact reverse bowden setup. ** Added light leak protection. ** Adjusted clearances. * Reworked the belt clamps on X carriage to eliminate belt slipping. * Simplified removal of the X carriage back bottom. * Improved screw holes on the X carriage back. * Improved spring tension of the extruder idler ==== Optional parts ==== * Reduced the size of filament sensor cover for reverse bowden setup. * Allow the use of drop-in tee-nuts with the reverse bowden v-slot mounts. * Updated the BOM for the extruder idler with bearing to use a dowel pin instead of Bondtech shaft. ==== Other ==== * Improved BOM, description and images. * Now on Thingiverse! * Switch to semantic versioning: semver.org. === Bug fixes === * #17 Centered mounting hole to hold X carriage and exturder body is off by 0.2mm bug. * #18 Hex nut pocket for POM nut is not tight enough. * #19 Try to find a way to not have the shroud's hex nut falling down. * #21 Unable to remove filament from bowden cover when filament sensor kick it because it is the end of the filament. * #22 Quick assembly image is showing GT2 instead of 2GT. === Compatibility === This extruder and x-ends are matched to each other and cannot be used separately. As a unit, they are completely compatible with stock Prusa MK2.5, MK3, Bear Upgraded MK2.5, and Bear Upgraded MK3. === Parts that needs to be replaced since release 0.50-alpha === Unfortunately, all parts have changed and need to be re-printed. === Special thank you === * To Matthew Humphrey for helping me to improve hotend cooling * To Nathan, he is preparing an awesome assembly guide! * To Bear upgrade FB community for your support and help! * To "The 602 Wasteland" community for your support and help!