Skip to main content

Revision to Bear FAQ

Matthew Harrison

I use genuine Gates idlers from E3D.
+== My screws and nuts are floating, is there a problem with the design? ==
+All Bear parts are designed to accomodate standard hex and square nuts with a snug fit. If you are finding that your nuts aren't staying secured or are spinning within their socket, this is most likely caused by under extrusion in your prints. Refer to our extrusion multiplier calibration guide here:
+== Is the Bear extruder compatible with the original stock X axis? ==
+Due to a different belt path, the Bear extruder and X axis are matched to each other and cannot be used separately. As a unit, they are compatible with both Original Prusa and Bear Upgrade frames.

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes