Skip to main content
Help

Revision to Bear FAQ

Grégoire Saunier

* The Bear frame from our official distributors
* The Bear extruder (with the calibration firmware used only for calibration and selftest)
+* The BearMera extruder
You need to use our recommended filament and print settings because those are the conditions used to design and test our products.
-We are providing optional parts for other extruders or hardware but unfortunately we don’t have time to test them and so we can’t support them officially. Those optional parts might require different firmware on which we have no control and don’t know how well they are tested. Please refer to their manual, assembly instructions and support.
+We are providing optional parts for other extruders or hardware but we don’t enough printers and hardware to test all the combinations. This means we can’t support them officially. Those optional parts might require different firmware on which we have no control and don’t know how well they are tested. Please refer to their manual, assembly instructions and support.
== Which Full Bear frame do I have? ==
The Bear X-Ends are compatible with the Bear Extruder, MK2.5 and MK3. They are also compatible with the BondTech Prusa upgrade extruder if you use the appropriate X-Carriage.
-== I am using the Bear MK3S Extruder (from the dev branch on GitHub), and I cannot pass xyz calibration. How can I get it to calibrate? ==
+== I am using the Bear MK3S Extruder and I cannot pass xyz calibration. How can I get it to calibrate? ==
This is a known issue which is caused by the difference in height between the stock Prusa MK3S extruder and the Bear MK3S extruder.
Disclaimer: The use of any non-Prusa firmware linked here is provided “as is” without warranty of any kind, either expressed or implied, and is to be used at your own risk. We encourage people to use genuine products and firmware from Prusa.
-== I have a MK2S Bear and want to use the Bear X-Ends. Is there a MK2S version of the Bear Extruder? ==
+== I have a MK2S printer (original Prusa or Bear frame) and want to use the Bear X-Ends. Is there a MK2S version of the Bear Extruder? ==
There is no official version of the Bear Extruder which suits the MK2S.

To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.

Revert Changes