Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
  1. Insert wisdom here. Insert wisdom here.
    • Insert wisdom here.

  2. We are going to test a little bit your dexterity in this step :) . Prepare the following hardware: 2x M4x10 screws (reused from your Original Prusa).
    • We are going to test a little bit your dexterity in this step :) .

    • Prepare the following hardware:

    • 2x M4x10 screws (reused from your Original Prusa).

    • 2x psu_upper_mount.

    • Place the M4x10 screw in the internal hole of the psu_upper_mount.

    • If you struggle to do it you can insert a finger in the big vertical hole (check the 3rd image). Like this you can hold and guide a little the screw.

    • Insert the other M4x10 in the remaining psu_upper_mount.

    • Now try to not loose the screw until we are bolting them on the PSU :D

  3. The next steps are for the Prusa silver PSU only. If you have the Prusa black PSU, go to step xxx
    • The next steps are for the Prusa silver PSU only.

    • If you have the Prusa black PSU, go to step xxx

    • If you don't know which PSU you have, please check the second image.

    • Prusa black PSU

    • Prusa silver PSU

    • Image copyright: Prusa Research

Grégoire Saunier

Member since: 1/20/19

22,906 Reputation

35 Guides authored

View Statistics:

Past 24 Hours: 5

Past 7 Days: 20

Past 30 Days: 64

All Time: 17,488