Changes to Step #1

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Pinda adjustment
-[* 9] Ensure the hotend have cooled down and turn off the printer.
+[* 9] Ensure the hotend has cooled down and turn off the printer.
[* 6] Place a sheet of paper on your heated bed. Remove any residual filament going out of the nozzle.
-[* 2] Center your extruder on the X axis. Move it down by rotating simultaneously the Z lead screws. Go down until the nozzle is just touching the paper.
+[* 2] Center your extruder on the X axis. Move it down by rotating the Z lead screws simultaneously. Move the extruder down until the nozzle is just touching the paper.
[* 4] Go down until the nozzle is just touching the paper.
[* 7] Place the middle section of a zip tie under the Pinda.
[* 5] Release the M3x10 screw and gently press down the Pinda against the middle section of the zip tie.
[* 5] Tighten the M3x10 screw.