Changes to Step #2

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Trapezoidal nuts adjustment
[* 1] Turn off the printer if it is powered on.
[* 1] Place a piece of paper on the heated bed to protect it.
-[* 1] Plug and turn on the printer.
-[* 6] Using the screen menu, move the X axis up until it crashes in the Z tops.
+[* 1] Plugin and turn on the printer.
+[* 6] Using the screen menu, move the X axis up until it crashes in to the Z tops.
[* 5] Turn the lead screws by hand to ensure both side are applying more even pressure to the Z tops. You might feel a step moving, on one side or both.
[* 4] Move the Z axis down to approximately 10-15mm from the heated bed.