Changes to Step #13

Edit by NATHAN M. DENKIN —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z calibration preparation
-[* 1] Heat up the nozzle and insert PLA filament.
-[* 5] Run Z calibration.
+[* 1] Heat up the nozzle by selecting Settings -> Temperature -> Nozzle: and insert PLA filament.
+[* 5] Run Calibration Z. You may repeat the procedure.
[* 10] Because the extrusion multiplier and filament diameter are not calibrated yet, it will only give a first approximation of the first layer height.