Changes to Step #8

Edit by NATHAN M. DENKIN —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Download Bear firmware for calibration
-[* 10] To improve reliability and quality we have designed the Bear extruder slightly taller in Z than the original MK2.5S and MK3S extruder. We then need a custom firmware to pass the Z calibration and selftest. After those steps we recommend to flash stock firmware again. However, you have the choice to keep using our custom firmware at your own risks.
-[* 9] We cannot be responsible of damages caused by our custom firmware. However, to reduce as much as possible the risks we kept the changes on the firmware as low as possible and they are documented here: [https://github.com/bear-lab-3d/Prusa-Firmware|github.com/bear-lab-3d/Prusa-Firmware]
+[* 10] For improved reliability and quality the Bear extruder slightly taller than the R4 MK2.5S/3S extruder. We provide customized firmware (FW) for the Selftest and Calibration XYZ and Z. After those steps you have the choice to keep using our customized FW or flash stock FW. In either case, you use our FW at your own risk.
+[* 9] We cannot be responsible for any damage caused by our custom firmware. However, to minimize potential the risks, we limited firmware to allow for the extruder height and document them here: [https://github.com/bear-lab-3d/Prusa-Firmware|github.com/bear-lab-3d/Prusa-Firmware]
[* 1] Select and download the latest Bear calibration firmware here: [https://github.com/bear-lab-3d/Prusa-Firmware/releases/latest|github.com/bear-lab-3d/Prusa-Firmware/releases/latest]:
[* 1] ***MK3S Einsy-Rambo 10a*** firmware name example: ''Bear_Cal_FW123_MK3S-EINSy10a.hex''
[* 1] ***MK2.5S Mini-Rambo 13a*** firmware name example: ''Bear_Cal_FW123_MK25S-RAMBo13a.zip''
[* 1] ***MK2.5S Mini-Rambo 10a*** firmware name example: ''Bear_Cal_FW123_MK25S-RAMBo10a.zip''
- [* 10] MK2.5S firmware comes as a ZIP files containing several languages of the firmware. Extract the ZIP file and choose the language you prefer the most.
+ [* 10] MK2.5S firmware comes as a ZIP file containing several languages of the firmware. Extract the ZIP file and choose the language you prefer to use.
[* 10] If you don't know which Mini-Rambo board you have, please refer to [https://www.prusa3d.com/downloads/firmware/EN-how-to-choose-firmware-MK25.pdf|this document]