Changes to Step #10

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Verify slicer version
-[* 3] Start Slic3r PE / PrusaSlicer software go to the top menu ''Help -> About ...''
-[* 5] If you are using Slic3r PE, verify that the version is equal or greater than 1.40.1.
+[* 3] Start Slic3r PE / PrusaSlicer software and go to the top menu ''Help -> About ...''
+[* 5] Verify that the slicer version is equal or greater than 2.0.0.
[* 1] If version is equal or greater: go to the next step
[* 1] If version is lower: download and install latest Prusa slicer from this page: [https://www.prusa3d.com/prusaslicer/|prusa3d.com/prusaslicer].