Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Flash Bear calibration firmware |
|---|---|
| + | [* 1] Turn on the printer and connect your computer to the Mini-Rambo / Einsy-Rambo with an USB cable. |
| + | [* 3] Start PrusaSlicer and navigate to the top menu ''Configuration -> Flash print firmware'' |
| + | [* 5] Select the Bear calibration firmware *.hex file using the ''Browse'' button. |
| + | [* 8] Verify that the printer is detected. |
| + | [* 7] Click the button ''Flash!'' to flash the Bear calibration firmware. |
| + | [* 9] Never turn off the printer or disconnect the USB cable while flashing the firmware! |
| + | [* 2] Wait until you get a ''Flashing succeeded!'' message. |
| + | [* 10] In case of issues while flashing the firmware read the [https://help.prusa3d.com/article/gXdRubco3u-firmware-updating-flashing-problems?code=400&failed=1&reason=Multilingual+is+not+enabled+on+this+account|Prusa troubleshooting article]. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added